![]() Usually I go for GLASS protectors not the silly “plastic” sheets. On preorder timeline there were not a lot of options for screen protectors. Close service door, re-install backglass, and return the backglass lock to the coin door.Īs a pre-order user for the Pixel 7 Pro I wanted a screen protector and case.You should see LX-8 displayed on the DMD.Īdjust settings as desired based upon STTNG_LX8.pdf manual in the proton drive archive. Open coin door and enter service mode using the buttons.You should be greeted with a “Factory Reset” message. Once you’re sure it’s installed properly power up the game.Verify the notch orientation a final time.We’d suggest taking the time to install a fresh set so that you don’t have the batteries leak. Inspect newly installed rom to insure no pins are bent and that you didn’t offset during install.The pins can bend under the package so best to do it with a flash light. Watch during installation to make sure no pins are bent as the rom is installed in the socket. The notch should face the right hand side of the game. Carefully install the new LX-8 rom chip in the same orientation.Set old rom aside incase you want to back out this upgrade. It should be with the notch facing the right hand side of the game. Note the orientation of the existing rom. Using a chip puller carefully remove the existing rom on the CPU board. ![]() The reason why is explained in Chapter 4 (Troubleshooting) of their manual. Remove AA batteries to drain game settings.You shouldn’t need to remove speaker panel to install new rom. ![]()
0 Comments
Leave a Reply. |